Great model, my daughter was very happy with it. However, I reworked it a bit because the lower jaws of the small skulls were not visible. I set this and the large skull 5mm higher, printed it and set it as a profile.
sure thank you, but why then rate 3 stars because you dont like the model ? i am for sure not going to download a model which i dont like the design and then rate 3 stars. anyways thanks for the "updated" version
regards
could use a better supported version, I ran into a couple less than perfect spots with the auto generated supports. going to use this as a helmet stand. use PLA metallic oxide green and PLA sparkle black on X1C.