If you want a commercial license, check out my bio and get it from Patreon.

I use my old thinker purge bin design for my A1 and A1mini, but after both of this printer move to smaller table, I was not able to fit them in the same space with AMS on the side. So I was looking for some smaller bin design compare to my thinker purge bin.

But I did not see anything that I like, it either have logo or text on it. More importantly I want something to match the style for both A1 and A1mini that sits together. So, why not spend few minutes to design my own.

From this:

To this:

This print takes around 2h50m on A1, around 110g of filaments.

Dimension: L175mm x W128mm x H100mm. Wall thickness 1.35mm. It is overkill for the application, but I just want something solid.

You need to lift the higher side up a bit while sliding the pins under the printer. It is designed to be tight fit to holding bin in position. 

It needs to work with the purge guide to get the best result.

So the design started with the idea to having both A1 and A1mini as a set. I want simple, minimalist, and will do the job - holding poop.

All the curves and round are designed to be have a cohesive look with a1/a1 mini.

Design is simple part, but measuring takes me a while.

I also have found that the a1mini base side is not perfect 90 degrees incline, also there is space that I could potentially do some design to keep the bin in place.

Run some small test pieces to find out the slope and testing out the feature.