Update: Modified to be shorter and add the file.

Decide to design a filament guide, because i use a dry box (or a filament spool holder) on the side of the printer, and it's a bit tricky to feed the printer through the filament sensor. I used an existing screw on the printer to install on.

No supports

No brim

Need an M3 Screw because the one from the printer becomes too short and a PTFE tube that push through the part until it clicks in the filament sensor and then cut it flush to the part.

Go check the air filter that i design https://makerworld.com/en/models/125944#profileId-143915

And the dampers https://makerworld.com/en/models/125985#profileId-143913