standing document organizer by starman

starman

Household>Office

Print Profile(3)

All

0.2mm layer, 2 walls, 10% infill

Designer

8.6 h

1 plate

1.0(1)

0.2mm layer, 2 walls, 10% infill

Designer

7.4 h

1 plate

alternative connection parts

Designer

18 min

1 plate

Boost

Released

Description

a two part standing document organizer for all your office din a4 organization needs, in a normal and slim version. i also have them in “full” versions without gaps, but they consume a lot more filament. all of the models print on one plate each, connecting the top part with the bottom one with 4 connection parts.

IMPORTANT: if by any chance the connection parts are too tall and the bottom and top piece leave a gap, use the alternative connection parts!

Comment & Rating (2)

@Amn2009

Print Profile

0.2mm layer, 2 walls, 10% infill

This model is hard to print without risking bad quality or failure. What I mean is that the model itself is really not optimized for 3D printing. The tall pillars and support walls in between ended up moving forth and back, breaking connection between each other (hear the snapping all the time while printing), and at the top (bottom part) it caused layer shifts. The top half failed, and I had to spend time in TinkerCAD adding triangles for strength and support as seen in finished print.

The designer has replied

@starmanski

thank you so much for your review! i am really sorry that you experienced these problems, i had no problems with my a1 back then, but it was my first 3d model and i winged a lot of stuff that i would do much better nowadays. ill try to update the model in the future :)

No more