simple PLA spring (stress toy)
Copyright Claim
simple PLA spring (stress toy)
Boost
2
2
2
Print Profile(1)
0.2mm layer, 2 walls, 40% infill
Designer
47 min
1 plate
Boost
2
2
2
0
3
7
Released
Description
This is a simple spring test made in fusion 360 that turned out pretty well.
It also works well as a stress relieve toy.
Note: It only works good for compression, stretching it fine but rotation may destroy it.
P.S: printed in PLA at 60% infill with supports
Update: version with keychain attachment added !
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 40% infill
Supports did not come off easily
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld