5mm Nut Keeper（for Kit-006 Jet Engine ）
Boost
49
71
50
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
10 min
1 plate
Boost
49
71
50
0
256
199
Released
Description
5mm Nut Keeper: A Handy Solution for Tight Spaces in Kit-006 Assembly
Assistance for Securing 5mm Nut in Tight Spaces for 3D Printing Design:
This design aids in securely fastening a 5mm nut in confined spaces, specifically intended to assist in the assembly of the Jet Engine Model for Kit-006.
Layer Height: 0.2mm
No Supports Needed
Comment & Rating (50)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
good job
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
real lifesaver for the jet engine
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Good 👍🏻
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
fast a cheap...oh wait, nvm
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Really usefull, Thanks !
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
I battled with the nuts for a little while till I remembered I had saved this. I extended the arm (added cube and resized) in studio and gave it a bend while it was still warm off the bed to make it easier to manage. Top tool, thank you :)
0
Reply
this is a lifesaver!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed very well and was very handy putting the engine together
0
Reply
top und sehr hilfreich :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
is a very handy tool but wish it had a spot to hold the washer as well. I think it does since I'm using it again but my shaking hands make it fall out.
(Edited)0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld