This is an WLED controlled LED lamp. Its made of 19 identical pieces and a base which holds the controller.

What you need:

• 40cm of WS2812B (5V) LED
• 1 x Node MCU V2a soldering iron, some solder and some cables
• 30x M3 x 20mm screws
• 30x M3 nuts
• 3x M4 x 50mm screws

Optional:

• a power socket 12V DC 5.5x2.1mm: https://www.amazon.de/dp/B09Z6W93X3?ref=ppx_yo2ov_dt_b_product_details&th=1

How to build:

• Print the Triangle Part and the middle window 19 times and all other parts a single time
• Connect them with the M3 screws and nuts
• Solder and glue the LED stripe on the lightbulb part
• Solder the LEDs to the NodeMCU below
• Put the diffusor over the LEDs
• Put the connector to the triangles on top and the controller box below
• Now put this together with the M4 screws
• If you want you can put the feet over the screws to hide them
• Test if everything works as it should and screw the rest of the lamp to the controller box
• Clip the middle windows into place
• This sounds a lot but if you hold the parts in your hand its easier than ikea!

This sounds a lot but if you hold the parts in your hand its easier than ikea!

How to flash your ESP:

• go to https://kno.wled.ge/basics/getting-started/ or https://install.wled.me/
• follow the instructions to flash the ESP
• if you have problems and need help, contact me :)

The filaments i used:

• Filamentums Crystal Clear PLA in Icelandic Blue
• Anycubic Black PLA

Have fun with this project, if you have any questions or problems feel free to contact me :)