The perfect chain oiler
Copyright Claim
The perfect chain oiler
Boost
5
5
11
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Boost
5
5
11
0
26
16
Released
Description
This chain oiler is specifically crafted for a 520 chain but is also suitable for use with other chain types. The length of the oiler is 150.78mm, making it shorter than any other chain oiler I've come across. I chose this compact design because the tube on my spray can was too short and couldn't reach the hole. Nonetheless, with this model, it's not an issue since you can always trim the tube to your desired length. :)
Comment & Rating (11)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
nicely done and thank you! 🙏
(Edited)1
Reply
Replying to @Wireway3D
Thanks
(Edited)1
Reply
I feel this could be improved if the hole split into two holes, with one hole over each of the chain's o-ring areas.
The designer has replied
0
Reply
you’re definitely right. I will look into that!
1
Reply
Replying to @Wireway3D
any progress? I like this design--I like the angled head so the can doesn't have to be fully vertical. just need the spray to be split onto the o-ring areas of the chain :-)
0
Reply
Replying to @BartmanEH
i haven’t had the time yet. a lot of other stuff has taking all my time. have u tried this? all my friends who has been prototype testers love this and they ride a lot of bikes. 😀
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thank you! 🙏
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld