PTFE Extension Adapter 4mm (0.2 nozzle only)
Copyright Claim
PTFE Extension Adapter 4mm (0.2 nozzle only)
Boost
60
151
5
Print Profile(1)
Standard Profile
Designer
59 min
1 plate
Boost
60
151
5
0
148
41
Released
Description
PTFE Extension Adapter 4mm
Simple adapter to extend your 4mm outer diameter, 2.5mm inner diameter PTFE tubes for longer reach.
Instructions & Requirements
- 0.2 nozzle is required!
- Please use purple glue since the parts have small footprint on the bed.
- Profile is optimized for the best print result.
- The adapter has a custom support adhesion.
- After print, please use a flush cutter to remove the support.
Profiles
- Non-AMS Version
Disclaimer
Print quality is base on your filament brand, filament parameters and environment; please take research for the optimal printing quality. Profiles are optimized to ensure text is clear, minimal banding and minimal ghosting.
Updates
Version 1.0
- Initial Release
Comment & Rating (5)
All
Print Profile
Standard Profile
printed great. i used a brim to keep adhesion on the bed slinger mini 👍😊
0
Reply
Print Profile
Standard Profile
parts got ripped off everytime while printing. it failed on 3 different plates. A1 Mini 0.2nozzle esun pla+ (dryed)
0
Reply
Print Profile
Standard Profile
I had to add support for the very bottom part of the thread to make it stick to the A1mini plate but otherwise print fine and works well to connect PTFE tubes together
0
Reply
Print Profile
Standard Profile
0
Reply
Print Profile
Standard Profile
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld