Ecoflow Delta 2 Remote AC trigger:


This is a remote AC trigger for the Delta 2.
My Delta 2 i normally placed close to the wall, making the switch on the back impossible to reach. I made this remote trigger for the Delta 2 (can be used for other) because I was frustrated always using the App to power on/off AC output.
This trigger can be placed on the front or anywhere else it makes sence for the user.
 

Material needed:
- Bowden tube
- 2 pcs. PC4M6 fittings 
- And a 3D printer :-)

I have printed this using PBT+ (a nylon like filamen), I have not tested with other filaments, but I expect PLA, PETG ect. to also work.

Fit the PC4M6 Fittings:
 

Clean them with degreaser (silicon remover) ect. to make the doubleside tape to stick:

Mount the “remote switch” right over the AC switch on the back of the Ecoflow. Make some fitting test before final fit. 
Bend some filament and insert it to the hole like the picture below. A ball pen spring can be used for better retact.
Same procedure for the “remote pusher" on the front or where the prefered location is.

Print the 150mm bowden to fix the bowdentube along the side of the ecoflow