I couldn't find a holder for a coin return switch on suzohapp style coin doors that also included a spot for a 5mm LED, so I made this. Note that my coin door seems to be fairly generic, and may or may not be true to the real suzohapp dimensions, so your mileage may vary. The switch type I designed this for is the 7mm round momentary pushbutton switches, readily available in a lot of places including amazon. They're sometimes used as tiny Service Buttons. I recommend getting the red buttons if your coin return button is mostly translucent red. I designed the LED hole to be a press fit for my 5mm LEDs, but depending on your LEDs and print tolerances, you may need to tape over the back of the LED to keep it in place, or add scotch tape directly to the sides of the LED for a snug fit.

NOTE: V4 is the version I'm currently using on my coin door, and is a little bit shorter than V3, and has one of the screw holes slightly re-adjusted to better match the screw holes on the coin door.

I printed it in PETG, but it should work fine with PLA. The material needs to be a tiny bit bendy to match up with the screw holes, so you may want to avoid ABS or any very rigid filaments. Note that you'll want to print it on the side if you don't want to add supports (by "the side" I mean it should look like a letter C on the build plate when looking at it from the top).

This is a fairly minimalist design with the sides removed and not a complete "box". Leave me some comments if a complete box would be better for your use case, or feel free to remix it.

Creality

No

0.2mm