The RIP Gravestone is available in several models including a spooktastic Halloween decoration and a desktop holder for pencils, pens, markers, and more!

RIP Gravestone (Halloween Decoration)

• One model includes glue holes for the insert, and another model without the holes.

RIP Gravestone Pencil Holder

• One model includes glue holes for the insert, and another model without the holes.

RIP Gravestone Insert

• Lay the insert over the face of the RIP Gravestone and press into place.
• Glue is not required but if you'd like to glue the insert into place please print the desired model with holes included.

Gluing Instructions:

• Lay the RIP Gravestone on it's back so the lettering is facing upwards
• Add a drop of glue in each glue hole
• Lay the insert over the face of the RIP Gravestone and press into place
• Wait for the glue to dry before turning the RIP Gravestone upright

Print Settings:

• Enable support with 30° threshold angle
• Concentric top surface pattern
• 0.08mm layer height for more detail
• 0.2mm layer height for a faster print

Notes:

• Support is recommended to preserve some of the detail. It's minimal and easy to remove.
• Shown as printed at 0.08mm layer height