Fully 3D printed magnetically stackable rugged storage box. No screws and nuts are required for the assembly.

Why not print-in-place:

At first the idea was about print-in-place model to avoid the usage of screws and nuts, but that would result in only one size, due to build plate surface limitations. So the solution was an assembly models, but still fully 3D printable.

A solid .stp model of the organizers is provided, so you can easily create your owns.

The variants:

150x100 mm, 207x100 mm & 207x150 mm. Each model variant has its own folder.

The magnets:

ø10 mm neodymium magnets with different thickness. They are just used to prevent the boxes to slide, when placed one over other.

Please pay attention to the polarity of the magnets!

Printing tips:

The pins must be printed on their flat side with 100 % infill.

The latch is recommended to be printed with 100 % infill.