PIN CHALLENGE V2 - Think your 3D printer is dialed in? - Post your results!
Copyright Claim
PIN CHALLENGE V2 - Think your 3D printer is dialed in? - Post your results!
Boost
90
108
89
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
14 min
1 plate
Boost
90
108
89
0
376
475
Released
Description
Think your printer & filament are dialed in?
Well put your printer to the Ultimate test.
Rules are simple, print the challenge in the fastest time possible and post your results.
Filament Type:
Time:
Printer:
Settings you changed:
Best of luck!
Comment & Rating (89)
All
13m 15s on my P1P
1
Reply
Filament Type: Bambu PLA Basic
Time: 14m
Printer: X1C
1
Reply
Filament Type: BambuLabs PLA
Time: Print time - 4mins 38s
Printer: X1C
Settings you changed:
- Speed to 500mm/s
- Lower the acceleration under 2000mm/s^2
- Variable Layer Height
1
Reply
Crazy hard print, guess I will need to work on better results.
Filament Type: PolyTerra Matte White PLA
Time: 6min 58 Seconds
Printer: X1-C
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Accidently created a hexagonal rose.
0
Reply
13 mins 05s
A1
0
Reply
Generic PLA
21 min all in
A1
0,2 mm standart BBL A1
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Perfect to check calibration of my P1S
(Edited)
0
Reply
Filament Type: Sakata PLA 850 Grey
Time: 15m
Printer: Custom 3d printer
Settings you changed:
0.2m layer
0% infill
vase mode
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
great fun to do and watch, thanks
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld