Raspberry Pi Pico Case
Copyright Claim
Raspberry Pi Pico Case
Boost
16
29
15
Print Profile(3)
Bottom 0.2mm layer, 3 walls, 20% infill
17 min
1 plate
Top 0.2mm layer, 3 walls, 20% infill
19 min
1 plate
0.6mm nozzle, 0.16mm layer, 1 walls, 5% infill
29 min
1 plate
Boost
16
29
15
1
89
74
Released
Description
A simple 2 parts snap-fit case for Raspberry Pi Pico. No screws needed. Back of case is open for wires. I use it to connect 2 ADXL345 and do the input shaper in Klipper
Print settings:
- layer: 0.16 or lower
- perimeters: 3
To connect 2 ADXLs use the following pins. For the second ADXL you will need to use GPIO8, GPIO9, GPIO10 and GPIO11 according to the colors. Red and Black are the same.
Klipper Configuration
[mcu pico_adxl345]serial: /dev/serial/by-id/usb-Klipper_rp2040_use_your_id-xxxxx[adxl345 head]cs_pin: pico_adxl345:gpio1spi_bus: spi0aaxes_map: -z, x, -y #update your axes mapping[adxl345 bed]cs_pin: pico_adxl345:gpio9spi_bus: spi1a[resonance_tester]probe_points: 115, 115, 30 #update your positionaccel_chip_x: adxl345 headaccel_chip_y: adxl345 bedIf you need a bed mount for ADXL take a look at this.
Updates
21.11.2022 - Add pins and Klipper configuration
22.07.2022 - Version 2.1 - add a cutout for the Bootsel button.
12.07.2022 - Version 2 - add an indentation in order to make the case more snap-fit and prevent to become too lose from wearing.
Comment & Rating (15)
All
Boosted
Print Profile
0.6mm nozzle, 0.16mm layer, 1 walls, 5% infill
very nice. good tight secure fit.
(Edited)
0
Reply
Really cool print! Snaps into place easily.
0
Reply
Good with 0.6 nozzle
0
Reply
Print Profile
Bottom 0.2mm layer, 3 walls, 20% infill
Profile worked perfect other than slowing things down a bit on my P1S as it was printed in Polymaker ASA.
0
Reply
Print Profile
0.6mm nozzle, 0.16mm layer, 1 walls, 5% infill
carbon fiber cf pla print (dried) wouldn’t complete the model. after three layers failed to adhere. could be printer issue
0
Reply
Print Profile
Bottom 0.2mm layer, 3 walls, 20% infill
The print was quick and turned out really nicely on the P1S default bed
0
Reply
Print Profile
Top 0.2mm layer, 3 walls, 20% infill
Turned out perfect, snapped together quite tight. Great model!
0
Reply
Print Profile
Top 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
Bottom 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
Top 0.2mm layer, 3 walls, 20% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld