Legs for Self or Monitor Riser
Legs for Self or Monitor Riser
Boost
55
77
4
Print Profile(1)
0.12mm layer, 4 walls, 15% infill
Designer
34.3 h
4 plates
Boost
55
77
4
1
117
54
Released
Description
Simple set of legs for any self-project with 1-inch to 3-inch extension legs. Note the leg extensions are made to press fit and not be removed for stability. Raw Fusion 360 Files included. Screw holes are made of #8 (US not Metric) screws with 82-degree countersink.
Comment & Rating (4)
All
Print Profile
0.12mm layer, 4 walls, 15% infill
Hey! so the legs printed beautifully but I’m having issues with the extension legs.
As yoy can see below, the extension legs have a slightly different angle than the base legs, so that the flat edges on the extensions are longer and the 45 degree angles are shorter to make up for it.
I thought it was my printer but then compared the models closer in Bambu to confirm it.
I’m also having a very difficult time getting the extensions to slide all the way in to the legs.
Thoughts?
(Edited)
0
Reply
Boosted
Print Profile
0.12mm layer, 4 walls, 15% infill
impression nickel en ABS, pour le bureau de mon fils, c'est nickel. belle réalisation
0
Reply
can i print this without supports with 0.2 standard?
0
Reply
Print Profile
0.12mm layer, 4 walls, 15% infill
Looks great and very strong and functional. I used these legs to make a riser for my 24” monitor.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld