A1 mini Poo Box (Poop Box) - bigger one by intommy

intommy

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

2.8 h

1 plate

4.7(11)

Boost

135

Released

Description

New model printed on A1 mini with strongest wall is here
********************

Sometimes people say that the wall is too thin, there is also a step available in raw files, where you can set the wall as you wish.

********************************
Although it is for A1 mini, it is printed on P1P (because of the size). If you have a 10-hour AMS print, such small boxes may not be enough.

I tried several boxes on the A1, finally I made my own..
Problem 1 I had was that the printer sometimes threw the poop completely outside the box. This version of the box, at least in lower positions (up to 6-7 cm high), ensures that this does not happen.
Problem 2 with throwing out of the box could be solved with just a cover, but I also tried that and still occasionally stepped on it on the ground. (Of course, the solution is to have the printer near the wall or something that does not allow this, but I have it in the space)

Comment & Rating (20)

@Maeusel

Print Profile

0.2mm layer, 2 walls, 15% infill

Ein bisschen sehr dünnwandig, tut aber was es soll!

The designer has replied

@intommy

Ich habe bereits ein neueres Modell erstellt, stärkere Wände, der Link ist in der Beschreibung. Allerdings ist dieses Modell voll funktionsfähig, allerdings hatte ich auch Probleme damit, wenn ich das falsche Material verwendet habe

(Edited)

@intommy

here some photos New one

@Maeusel

Danke! das sieht schon sehr viel besser aus, Das sollte ich mir dann noch mal neu drucken!

@dleone617

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed great on the A1. I would prefer a little thicker walls, but this will due! Thank you.

(Edited)

The designer has replied

@intommy

Hello and I'm glad you like the model. of course, it is not a problem to increase the thickness of the walls. I have attached the STEP and Fusion 360 file to the RAW downloads. Of course, if the model has been scaled down to fit the A1 surface, the walls are thinner than usual against 1:1 printing on P1

(Edited)

@intommy

I have prepared a new model that should be able to be printed on A1 Mini without any problems - size 176x176x140mm Of course, the wall is thicker - 1.6 mm - and also the extrusion on the larger side to make it stronger. Printing time on A1 mini is approx. 3.5 hours. (The speed can be increased to 140% without any problem thanks to the simple shape) I will finish the test print and the model will soon be available for download on my profile.

@dleone617

thank you! will print as soon as I can ;)

(Edited)

@Jim2print

Print Profile

0.2mm layer, 2 walls, 15% infill

Now this could of been my own fault, but I’m mounting to support brackets to the side of table for the printer. but I did notice the walls that are standard are a little thing. by the bottom of print front face it cracked, and the top lip cracked off. definitely going to make the wall thickness a little bigger for the next one I print. overall great.

The designer has replied

@intommy

I personally don't have a problem with the model, but my friend cracked it and glued the inside with thin plastic and everything is fine. In any case, there is a STEP and Fusion 360 file available for any modification and setting of the wall thickness

(Edited)