Remix file of mikes2277 https://www.thingiverse.com/thing:4689019 for 4.3" monitors on Flying Bear Ghost 6 plus support for Logitech C270.
at the following link you will find the video for assembly.
https://youtu.be/E6d9l8nYf4w
Material needed:
11 M3X5 inserts https://bit.ly/insertM3
4 M3x6
4 M3X8
4 M3X14
1 M3X18
1 M3x20
1 M5X22
5 Nut M3
1 Nut M5
Monitor 4.3" https://www.amazon.it/dp/B08CH24YYD?ref=ppx_pop_mob_ap_share
Project for Logitech C270 https://www.thingiverse.com/thing:5643030
Lens adapter https://www.thingiverse.com/thing:5530338
Lens https://bit.ly/LensAdaptor
Use the soldering iron to secure the hot inserts into the plastic.
If you print in a closed chamber, use a material that resists high temperatures for the webcam part. for the monitor part, PLA is sufficient.
A special thanks to Станислав from https://t.me/fbg5_waiters and to Sergio Lorenzi From https://t.me/flyingBearGhost5 who helped me to carry out the project.
Remix del file di mikes2277 https://www.thingiverse.com/thing:4689019 per monitor da 4.3" su Flying Bear Ghost 6 più supporto per Logitech C270.
al seguente link troverete il video per il montaggio.
https://youtu.be/E6d9l8nYf4w
Materiale necessario:
11 inserti M3X5 https://bit.ly/insertM3
4 M3x6
4 M3X8
4 M3X14
1 M3X18
1 M3x20
1 M5X22
5 Dado M3
1 Dado M5
Monitor 4.3" https://www.amazon.it/dp/B08CH24YYD?ref=ppx_pop_mob_ap_share
Progetto per Logitech C270 https://www.thingiverse.com/thing:5643030
Adattatore per lente grandangolo https://www.thingiverse.com/thing:5530338
Lenti grandangolari https://bit.ly/LensAdaptor
Utilizzare lo stagnatore per fissare gli inserti a caldo nella plastica.
Se si stampa a camera chiusa per la parte della webcam prevedere un materiale che resista alle alte temperature. per la parte monitor è sufficiente il PLA.
Un Ringraziamento particolare a Станислав di https://t.me/fbg5_waiters e a Sergio Lorenzi di https://t.me/flyingBearGhost5 che mi hanno aiutato a realizzare il progetto.
Printer:
Flying Bear Ghost 6
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
30
Filament: Eryone PLA/ABS Any