Cube with a ball inside
Copyright Claim
Cube with a ball inside
Boost
31
52
25
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
33 min
1 plate
Boost
31
52
25
0
179
191
Released
Comment & Rating (25)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Ein sehr schönes Modell, vielen Dank dafür
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
beautiful print, but I may suggest some attention to the bottom layers of the cube. The overhang was too challenging
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The ball didn't stick to the bed enough and came loose at the end. Still a nice design tho.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
failed. Will try again at 50% speed once I have more filiment. just starting out so one spool at a time
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice Ball has a flat but it still is good and prints easy!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Kool print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fun little print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:I had some problems with getting the ball to stay on the bed, even after cleaning and pre-heating it. The ball kept coming off mid-print. I think a small brim could be useful.
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld