AMS and drybox filament and temperature reminder. Easy to use gadget for the many different filaments and temp settings.

I was mixing types of filaments of the same color forgetting what each one was, and when reloading with different filaments from different manufactures trying to remember the temp it needed for proper printing. Not finding what I needed, I just made it myself and hope others find it as usefull as I do.

Printed everything on the Textured PEI Plate.

Small parts print with outer brim

Screw tower print with outer brim in the upright position

Support at 12%

Screw tower after printing the supports easily snap off

The Knobs for the top are a tight fit and a light sanding / filing on the top of the screw is advised to your own preference.

-= Building it =-

Fit everything together and make any final touches with a file or sanding.

Put base down

Put the pointer on the screw

Insert screw into bottom hole

Put the Top bracket on screw and angle it to the side a little from the top corner

Dab a little glue where the top bracket sits and connect them together

I did glue the Knob on but depending how tight your fit is you may not need it.

Stick it in place with double sided tape.

Enjoy!