Flipper Zero TPU case
Copyright Claim
Flipper Zero TPU case
Boost
11
33
11
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
3.5 h
1 plate
Boost
11
33
11
2
68
51
Released
Description
I modelled this case off of the official files from flipper, it is close to the silicon case that they sell. Print this in TPU and reduce your volumetric output.
Comment & Rating (11)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
Used 95a TPU, supports were difficult to remove and resulted in a rough print.
The designer has replied
0
Reply
let me check my printer profiles, I adjusted supports to make removal a bit easier and came out with great prints with easy tpu support removal!
(Edited)1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Thanks for the profile the support painting could use some cleanup.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
came out decent. supports came off nicely. only reason for 4 star is the one bottom corner went all weird.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
If you are planning on printing this, erase all the supports on the bottom or it. They aren't necessary. It printed well after that. only thing is, it got a little warped on one side but who cares
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
support issues when removing the internal support
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Turned out suprisingly well.
Printed in eSun TPU 95A.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
great
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld