Vacuumbag Valve/Pump Adapter by matziwe

matziwe

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.12mm layer, 2 walls, 15% infill

Designer

59 min

1 plate

4.8(25)

A1 Mini 0.12mm layer, 2 walls, 15% infill

1.1 h

1 plate

4.7(3)

Boost

122

124

Released

Description

Description:

I store most of my filament rolls in these “vacuum”-bags. When sucking out the air of this bag, the pump directly sits on the bottom of the bag and its very hard to get the air out. So, i designed this little adapter where the pump can lie on. Underneath the pump there are a few outlets to let the air flow through.

Printing:

Print the adapters as shown in the printing profile. Normally, you don't have to use supports to print it but the model will print cleaner if you do. I printed mine without supports.

Comment & Rating (28)

@jeremo1999

Print Profile

0.12mm layer, 2 walls, 15% infill

It didn't work for me, not sure if it is just my bags (although they look the same as in the creators pictures) or if my vacuum isn't strong enough or what

@MarcoDB

Print Profile

0.12mm layer, 2 walls, 15% infill

Marche nikel merci

(Edited)

@user_3703514980

Print Profile

0.12mm layer, 2 walls, 15% infill

works very well. good job

@andreas.berch

Print Profile

0.12mm layer, 2 walls, 15% infill

Problemlos mit PLA gedruckt und funktioniert sehr gut. Die Vakuumbeutel sind damit viel einfacher auszusaugen und ist damit für mich sehr nützlich. Danke fürs teilen!