Note: Model originally by Matija (@Matija_272939) on Printables
As stated above, this I did not create this model, but I did like it so much that I wanted to share it here too as it printed great on my X1 Carbon. I've included the 3mf for printing this in PLA. I personally printed it in PAHT-CF with ABS as a support interface (it works really well).
Note that the addition of this prop guard means the Mini SE no longer fits in the under 250g lightweight drone category - do with that information what you will.
Description from Matija's original post on Printables:
Printed with 0.4 nozzle, brim for extra adhesion and supports.
Sharp small scalpel is recommended to remove brim and extra material I've put on holders so it can be printed, it's only 1 wall thick and should be visible line that follow the contour of the drone.
After that just click everything in place but be aware that on front end one of the hands is shorter than the rest.
Since I've made this I have not tested it much so if you think it can be improved I can make adjustments.