Since the Bowden connector used on these printer models are very prone to breaking, I designed this little clip that screws in to existing screws on the printer body. It will limit the range of movement of the filament feed tube, in an attempt to minimise wear on the connector.

All models that are based on the Malyan M200 series 3D printer could potentially benefit from using this.

Print Settings

Printer:

PrimaCreator P120 v4

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

25%

Filament:

add:north E-PLA

White

Notes:

Simple little thing. Small bridge, but nothing that would need supports.

Post-Printing =============

• Unscrew one of the two screws used to fasten the clip (see thing image).
• Place the clip according to the thing image
• Put the screw back lightly in place, but don't tighten yet
• Unscrew the second screw
• Swing the clip in place
• Fasten both screws, don't tighten too much
• Profit.

Category: 3D Printer Parts