12VHPWR Corsair Cable Comb by man1ac

man1ac

Hobby & DIY>Electronics

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

18 min

1 plate

5.0(1)

Boost

Released

Description

Looked for some Cable Combs for my Corsair (Original 12VHPWR) cable.

I use the 2PCIe to One Cable, havent tested if this works for the 3 in 1 cable. The dimensions are as tight as they could be. Any smaller and its almost unprintable with my .4 nozzle.

There are other versions on printables, but these werent anywhere near to be printed with my P1S. Settings needed some tweaking. The brim MIGHT not be necessary, but its easy to remove with a scalpel).

Comment & Rating (3)

@TeeeGG

Thank you for providing the model. After searching through several websites, it was hard to find one like this type of cable comb. The model turned out satisfyingly, fitting the cables perfectly. I used P1S for printing PETG.

@olivere7

Exactly the same GPU, Cable and rgb colour 😂Almost thought it was my setup.. Anyway, printed on A1 mini, textured plate using 0.2 strength preset on PLA @ 0.4 Nozzle, turned out great! Thanks for sharing the model!

(Edited)