Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.

Start with Black
At layer #7 (0.64mm) swap to Blue
At layer #13 (1.12mm) swap to Orange
At layer #18 (1.52mm) swap to White for the rest.

136x170 Version:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.
Start with Black
At layer #10 (0.88mm) swap to Blue
At layer #13 (1.12mm) swap to Orange
At layer #21 (1.76mm) swap to Jade White for the rest.

______________________________________________________________________________________

Check out my HueForge Wall mount:

https://makerworld.com/en/models/141236

___________________________________________________________________________________

If you like my work, please consider a small donation :) Thank you very much :*

https://www.paypal.com/donate/?hosted_button_id=RWRXKCAEM86K8