Dyson Attachment Holder Wall Mount
Copyright Claim
Dyson Attachment Holder Wall Mount
Boost
33
93
32
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
1.4 h
1 plate
Boost
33
93
32
0
177
213
Released
Description
This bracket attaches the wall with two screws to hold your Dyson attachments. it clips in place using the original Dyson clip mechanism and releases when you click the button. holds in place very firmly and will not come out unless the button is pressed.
(You can just use one screw to mount it to the wall however you may find it can rotate when inserting/removing the attachment)
This has been designed for my Dyson V12 attachments however I’m sure it will also fit other Dyson models.
Prints Without Supports
Print with largest flat side down on the build plate.
Comment & Rating (32)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
These worked perfectly for our Dyson v11. Thanks!!
(Edited)
The designer has replied
0
Reply
Thanks very much for your rating and feedback. I'm very pleased to hear they are compatible with your model of Dyson.
0
Reply
The print profile is no longer public
Top für nicht motor getriebene Aufsätze aus der V8 Reihe, hier passt der lochabstand leider nicht
The designer has replied
0
Reply
I have updated the model with a larger hole to allow this Dyson model to now fit. It should no longer conflict with the back piece. Thanks very much for your feedback.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
sehr robust und sehr gute Passform.
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Klasse danke
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Now I have pleasant wife and a pleasant life 😊
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
worked amazingly! got a new v15 for Christmas and the attachments snap into these like a charm
The designer has replied
0
Reply
Thanks very much for the nice comment and rating. Very glad they worked well for you.
0
Reply
excellent design and print in PLA, it's not quite correct but still works well with older V6 and V7 parts. Thanks!
The designer has replied
0
Reply
Thanks for the feedback. I’m pleased to hear it can work with the older models too.
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Toppie
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Love this design! perfect storage solution
0
Reply
Fits accessories nicely. Just what I was looking for.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld