Business Card Holder - Take One
Copyright Claim
Business Card Holder - Take One
Boost
42
59
17
Print Profile(2)
5% bigger, better supports, 0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Face Down for PEI plate, Supports
1.9 h
1 plate
Boost
42
59
17
0
120
100
Released
Description
Printed in PLA, 0.2mm, 10% infill, supports enabled.
For the supports, I tested it on the lying on the text face and text facing forward, both worked but the latter gave me better results.
If your printer is not very good at keeping supports removable, then I'd suggest you print it lying on the side, so only the businesscard gap needs support. If the support messes up, you can cut them away easily and the messy parts should be hidden (either by the Businesscard, or because its facing back.
Comment & Rating (17)
All
Print Profile
Face Down for PEI plate, Supports
Support Issue:not large enough to fit business cards
0
Reply
Print Profile
Face Down for PEI plate, Supports
0
Reply
Print Profile
Face Down for PEI plate, Supports
0
Reply
Print Profile
5% bigger, better supports, 0.2mm layer, 2 walls, 15% infill
works great
0
Reply
Print Profile
Face Down for PEI plate, Supports
Good print. I have printed for my friend... He was very happy
0
Reply
Print Profile
Face Down for PEI plate, Supports
The supports didn't quite work so needed to strengthen the model
0
Reply
Print Profile
Face Down for PEI plate, Supports
print did not fit a normal sized business card and the “O” did not print correctly on the back side. I think it was missing a support. would’ve been fine if I had caught that before I printed it. it would be fine if you just resize the opening for the cards by about 2-3mm.
0
Reply
Print Profile
5% bigger, better supports, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Face Down for PEI plate, Supports
0
Reply
Print Profile
Face Down for PEI plate, Supports
(Edited)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld