Finger Spinner - print in place - Fidget toy
Copyright Claim
Finger Spinner - print in place - Fidget toy
Boost
143
222
65
Print Profile(3)
OFFICIAL - 0.12 layer
Designer
16 min
1 plate
FAST PRINT - 0.2mm layer
Designer
12 min
1 plate
AMS 5 x spinners on one plate 4 to mix and match, 1st color prints 2 the rest are single
1.1 h
1 plate
Boost
143
222
65
1
352
703
Released
Description
A simple but satisfying fidget spinner. It's a very good antistress.
After printing in place it you can mix the colors to your liking.
You can print separately and add the third ring.
Very easy to print!
After printing rub the rings vigorously together to increase smoothness.
Use the highest quality for better smoothness.
If you have smoothness problems you can adjust the tolerance directly in the slicer. In Bambu studio you can edit the parameter “X-Y hole compesation” in “Quality” tab. XY Hole/Contour compensation | Bambu Lab Wiki
Plese, consider my other models:
Comment & Rating (65)
All
Print Profile
0.15mm - 4 walls - 15% infill
This is a favorite around our house!
1
Reply
Print Profile
FAST PRINT - 0.2mm layer
Se ha impreso bien 👍
1
Reply
Print Profile
OFFICIAL - 0.12 layer
Printed Great. No clean up.
1
Reply
Print Profile
0.15mm - 4 walls - 15% infill
printed great in PETG!
1
Reply
Print Profile
OFFICIAL - 0.12 layer
1
Reply
Print Profile
OFFICIAL - 0.12 layer
daughter loves it
1
Reply
Printed and functions great even at 80% size. I did need to slow down the first layer to get good adhesion on my PEO plate but, it turned out great.
1
Reply
really grate print printed multiple
1
Reply
Print Profile
OFFICIAL - 0.12 layer
printed 5 of this, no problem at all
1
Reply
Print Profile
OFFICIAL - 0.12 layer
printed perfect, great tolerances between the rings
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld