I needed an organizer that would fit an overhead hinged door and I came up with this tilt-up organizer to keep print stuff handy.
-Print the organizer with layer height 0.28mm, infill of 20% or more, wall loops of min 2, top layer min 2 and bottom layer min 3.
-Print arms with at least 30% infill.
-No brackets required.
If you like my designs give me like and share. If you like them a lot invite me to a coffee.
https://www.buymeacoffee.com/kjbturok
https://www.paypal.com/paypalme/ChinadlaConchinchina
ESPAÑOL
Necesitaba un organizador que se adaptase a una puerta abatible superior y se me ocurrio hacer este organizador basculante para tener las cosas de impresión a mano.
-Imprimir el organizador con altura de capa 0,28mm, relleno del 20% o más, bucles de pared de minimo 2, capa superior minimo 2 y inferior minimo 3.
-Imprimir los brazos con al menos un 30% de relleno.
-No necesita soportes.
Si te gusta mis diseños dale me gusta y comparte. Si te gustan mucho invítame a un café.
https://www.buymeacoffee.com/kjbturok
https://www.paypal.com/paypalme/ChinadlaConchinchina