Purpose
The Maglula “UpLULA” loader is designed to accommodate a wide range of magazines, which means its opening is a bit too loose for a fair portion of common magazines.
These printable inserts allow you to ease loading your specific magazine, especially single stacks.
Variants
- Metal 9mm Double Stack
Typical examples: Sig Sauer P226/229, P320; Beretta 92FS; MP shield;
- Polymer 9mm Double Stack
Mostly Glocks: G34/17/19/26, and other double stacks
- Metal 45ACP Single Stack
All the lovely 1911 and 2011s. MagLULA's official version of this can be found here, and mine serves the same purpose.
*For many manufacturers, their 9MM DS magazine shares the exact dimensions as the 38ACP and 40SW caliber variants; however a fit is not guaranteed so please try them yourself.
Design Features
- Chamfered opening to ease insertion
- Friction fit to UpLula, no glue or screws needed
- Unbossed text inside to identify matching magazine types
- Fast print time (45min on my printer)
Recommended Print Parameters
- More than 4 wall loops, 4 bottom layers, and 4 top layers
- Infill >15%
- No Support needed
- Brim suggested if bed adhesin is not very strong
- Depending on the dimensional accuracy of your 3D printer, you may need to adjust XY expansion/shrinking a little to get a snug fit.