Magnetic Bambu plastic poop chute
Copyright Claim
Magnetic Bambu plastic poop chute
Boost
13
21
21
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Boost
13
21
21
0
74
90
Released
Description
Includes Bambu logo on the front and an inset section on the rear to fit one of the magnets that comes with the Bambu P1S printer. Fit the magnet and the box can be fitted just beneath the waste chute.
Make sure to print with supports on the logo.
Comment & Rating (21)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Great simple poop collector to get me started on the P1S combo. Bonus points for using the magnet that was included for the scraper. Printed great on P1S with Bambu basic PLA
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice little box that does the trick. The magnets that came with the printer fit well. No need for bigger chutes.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Simple. Small. For beginners. Then you need somethinh bigger
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
cool Design
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Schönes Modell, aber Punktabzug für die Stützstrucktur, welche sich schwer von den dümmen Armen des Logos entfernen lässt
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
its ok
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The print is good. I can’t get it catch anything.
0
Reply
This came out awesome. I love the curved front edges. Nice work!
0
Reply
👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed well and looks good!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld