Z wobble test by SavageLau

SavageLau

3D Printer>Test Models

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

Z Wobble test for X & P series.

Designer

2.6 h

1 plate

4.6(7)

A1 mini Z Wobble, Y axis consistency test.

Designer

2.3 h

1 plate

5.0(2)

A1 mini z wobble test, one square on center

2.2 h

1 plate

5.0(2)

Boost

123

Released

Description

Hi guys, I made this test model to test my bambu lab printer Z axis. The length of the raw model is 240mm, almost reach the max of z travel. I upload print file for X, and P series, also for A1 mini.

Use filament color that shows layer line, don't use those matte or special blend filament.

Instruction:

So you will observe at the front to see any obvious uneven lay line: Mine looks good.

Then, in 45 degree angle:

Mine looks good tho.

If your's look like this: It is not good. (pic source: theprusaforum)

However, this picture below might be either uneven extrusion or z wobble, or both: (source reddit)

If your's z wobble looks like this: your model is moving due to the motion. add more brim. (source: theprusaforum)

I sliced for a1 mini: it is at 170mm, it will both test z wobble and the y axis consistance during high speed travel for tall object.

My A1 mini have some issue on the Y axis:

Comment & Rating (13)

@warmup

Print Profile

Z Wobble test for X & P series.

@Avacaca

Print Profile

A1 mini Z Wobble, Y axis consistency test.

The designer has replied

@vietfarmer21

my is uneven and wooble badly like your picture shown.. how do I fix the problem? any suggestion?

@SavageLau

Replying to @vietfarmer21 :

I won't worry about it if there is no significant defect while you printing normal model on the center. This is just to test the maximum potential of the a1. So, it tells you y axis duing high speeding printing around the edge area will not do well.