Baby Groot key chain
Remixed by
Copyright Claim
Baby Groot key chain
Remixed by
Boost
51
62
12
Print Profile(1)
0.2mm layer, 3 walls, 35% infill
Designer
1.4 h
1 plate
Boost
51
62
12
0
139
127
Released
Description
Supports are needed.
The hole for attaching the ring is at the back.
Ring diameter 1mm.
The height of the model is 10 cm.
Comment & Rating (12)
All
Just snapped the right arm clean off as way too many supports on it 👎
The designer has replied
0
Reply
I didn't have the slightest problem with supports. They went without problems and easily removed
0
Reply
I lost the fingers of his right hand when removing supports... has to be a way to remove them without fingers breaking off!!! Great model though.
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
such a cute print. too bad I snapped his arm off while trying to remove the supports on the one side. gonna try again
0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
Great model! Would benefit from using tree supports as the regular supports used for the hand are very difficult to take off.
0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 35% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld