Turning handle for Pastamatic Remixed by edzill

Remixed by

edzill

3D Printer>3D Printer Accessories

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.3 h

1 plate

4.8(45)

STURDY version

Designer

1.5 h

1 plate

4.8(17)

Reinforced Pin, Cleaned Supports

1.3 h

1 plate

4.9(11)

Boost

145

452

417

Released

Description

I remixed the handle created by Miklos from his filament spool switch and made it print in place. Big fan of the pastamatic but didn't want to go get my drill whenever had to re-spool something.

Made this handle to make it easy to re-spool something and keep everything you need to do it in one place.

I suggest you use my 3MF and only change your filament profile as I have adjusted support settings to be as easy to come off as possible. Using some pliers it took me about 5 minutes to take off the entire support structure.

Comment & Rating (99)

@maxman

Print Profile

0.2mm layer, 2 walls, 15% infill

Works great. I reoriented it to print on its side to use less supports.

The designer has replied

@edzill

nice! I wasn't sure if it would still rotate if I printed it that way which is why I did it the way I did. glad it still works though!

@Reality.2

Print Profile

0.2mm layer, 2 walls, 15% infill

fits perfectly

The designer has replied

@edzill

great!

@acevalsl

Print Profile

0.2mm layer, 2 walls, 15% infill

perfect

The designer has replied

@edzill

yay! Glad it worked for you.

@escollins01

Print Profile

0.2mm layer, 2 walls, 15% infill

the small little printed well and fit together perfectly. looking forward to using with my pastomatic

The designer has replied

@edzill

Glad it worked out well!

@Brant3D

Print Profile

STURDY version

Needed pliers to get the supports off but it works well

@mcginnis83

Print Profile

Reinforced Pin, Cleaned Supports

Fits perfectly in paatamatic parts

@dark_stranger

Print Profile

0.2mm layer, 2 walls, 15% infill

The designer has replied

@edzill

looks good!

(Edited)

@Jekosss

Print Profile

Reinforced Pin, Cleaned Supports

@AndyQ

Print Profile

0.2mm layer, 2 walls, 15% infill

No issues - fits the Pastamatic fine. won't use it for large reels (suspect that will be painful to use) but great for winding on small test batches.

The designer has replied

@edzill

There is a clip you can print that goes on the gear side, If you use that it shouldn't be an issue with a 1kg roll which is what I use it with

@AndyQ

Thanks - I also printed that and it works a treat! was contemplating on one for the other side too but it may be more of a nuisence and I'm not sure it's needed yet.

@edzill

Replying to @AndyQ :

I wouldn't unless it becomes an issue 👍

(Edited)