**Update 1/22/2017: I uploaded the .step files for your remixing pleasures.

This is a printable "teklok" style mount. Use this for your mag carriers, shotshell caddies, knife holsters, whatever you want! I don't recommend using it to actually carry a pistol though, while it may hold up it would be wise to simply use the real deal.

Instructions:

-Print the parts

-Drill out the holes that the dowel pins will go in with a 3/32 drill bit

-Press in two (one on each side) 3/32 diameter by 7/8 long dowel pins (ACE hardware had them for me)

Print Settings

Printer Brand:

LulzBot

Printer:

Rafts:

No

Supports:

Resolution:

.20mm

Infill:

Notes:

It would probably be best to print 100% infill, although the one that I printed at 50% has held up fine under light loads (double pistol mag carrier).