Gorilla Tag Keychain 2 colour
Copyright Claim
Gorilla Tag Keychain 2 colour
Boost
15
20
9
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
21 min
1 plate
Boost
15
20
9
0
57
82
Released
Description
Simple two colour model of gorilla tag logo made into a keychain.
Print time 13 minutes, 3 colour changes. Total filament usage 5.13g approx.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 100% infill
Not a bad print, the hold is a little bit too close to the end and may fail if pulled on (even moderately). I was putting it onto a backpack for a child so I also enlarged it by 30% as it's a bit on the small side but understandably so given that it's made for a key ring.
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
very good the kids love them
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
can this be made available for A1 mini? would love to create as a bday gift for my kiddo!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoDerivatives
© 2024 MakerWorld