X1c Hydrometer Door mount
Remixed by
Copyright Claim
X1c Hydrometer Door mount
Remixed by
Boost
70
119
108
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Boost
70
119
108
0
250
227
Released
Description
Remix of https://makerworld.com/en/models/38865#profileId-37736
Hole recessed so no additional screws required.
Moved close to the edge for more visibility through the door.
Now moved back from the glass to prevent vibration after constructive feedback.
Comment & Rating (108)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect with ABS on PEI plate
The designer has replied
0
Reply
Thank you for your feedback and rating :) Happy Printing :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice!
The designer has replied
0
Reply
Thanks for the review and rating. Happy Printing.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
In schwarzem ABS gedruckt, passt das Thermometer perfekt. Sieht super aus, danke!
The designer has replied
0
Reply
Du bist herzlich Willkommen. Viel Spaß beim Drucken.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Hard to snap a good photo through the door because of the reflections but printed this in PETG and came out perfectly.
The designer has replied
0
Reply
Thank you for your review and rating. That's a good picture as you can see it's away from the glass now to reduce vibration. Happy Printing.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works as intended.
The designer has replied
0
Reply
Thank you for your rating. Much appreciated. Happy Printing.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked perfectly.
The designer has replied
0
Reply
Thanks for sharing and you feedback.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
worked great thanks for the counterbore for original screws
(Edited)The designer has replied
0
Reply
Hi @Spyder.
This remix was to address that exact issue and it works for me and others that have rated. I'm sorry yours has not worked but my remix has been proven by many.
0
Reply
Replying to @MB3DX1C
sorry yours works great accidentally left that ment for the original
0
Reply
Replying to @MB3DX1C
fixed
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you for your rating. Happy Printing.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you for your rating. Much appreciated. Happy Printing.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fits perfecty with no need for new screws
The designer has replied
1
Reply
Thank you for your rating. Much appreciated. Happy Printing.
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld