Bambu Top Riser Remixed by KenPrint3D

Remixed by

KenPrint3D

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

1 color PLA 0.20mm

Designer

40 min

1 plate

5.0(7)

PLA 0.16mm

Designer

56 min

1 plate

4.3(6)

Boost

160

121

Released

Description

QUALITY ‣PLA 0.20mm

I added the logo, added chamfers and I removed the front to be more flat once opened and closed

Disclaimer: The use of the logo or character in this design is for illustrative purposes only and does not imply endorsement or sponsorship.
All trademarks, logos and characters are the property of their respective owners.
Any reference to specific brands is not intended to infringe upon or challenge the ownership rights of the trademark holders.
I respect the intellectual property of all brands and/or characters mentioned or used in this design.

Comment & Rating (19)

@AbeFM1

Seems to work fine. I did the pet-g 0.2 Quality, but found the bridged text overhangs not as nice and think I'd have liked them on the surface better since I'm using the AMS anyway. Very minor point, the print is functional and looks great. I also had the two bits stuck together, but as I wanted to remove the handle and screw it on more permanently anyway, I didn't mind.

The designer has replied

@KenPrint3D

yeah i dont use this kind of build plate as its not in the recommended choice of bambu for reasons :) thanks for sharing

@giuliandenicola

Print Profile

1 color PLA 0.20mm

As if you designed for me on purpose 10/10

@ollimertens

Print Profile

★ 𝐅𝐚𝐬𝐭 ‣QUALITY ‣PETG 0.20mm

After flow calibration it works perfect :D

@goatz6

Print Profile

PLA 0.16mm

Great mod fits nice and works, easy to print

@Kodikas

Print Profile

PLA 0.16mm

lettering came out a little rough, but still a nice print and useful, thanks!

@FabryTheOne

Print Profile

1 color PLA 0.20mm

percect print

@semisemisemi

Print Profile

PLA 0.16mm

Other Issues:unfortunately the dovetails fused together. cut the end piece off with a chisel and superglued it back on around the lib knob instead. in the future I would suggest putting parts that don’t have to be printed in place elsewhere on the build plate, since tolerances will differ.

The designer has replied

@KenPrint3D

In the future I suggest you tune your filament to have the perfect flow before printing the parts :) this model is 100% printed like this with tune in flow and works fine for everyone so far. also this is a remix and others have printed just fine this way :) thank you