Modern simple hook with invisible mount by Many24

Many24

Household>Other House Models

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

0.12mm layer, 4 walls, 50% infill

Designer

48 min

1 plate

5.0(2)

BBLmattePLA,0.16mm layer, 3 walls, 15% infill

30 min

1 plate

4.3(4)

0.2mm layer, 6 walls, 25% infill

1.5 h

3 plates

5.0(1)

Boost

Released

Description

When renovating our hall, we wanted some very simple, yet modern hooks, with possible no visible mounting points / screws. So I came up with this design.

The fit is quite tight, I wanted to have no play, so it might require some dialing.

There are small bumps at the end, so the hook clicks nicely in place:

Print instructions

Printed in PLA, but any material should do
Print front side down - mount side up for best printability and front visible finish
No supports needed
50% infill
4 perimeters

Additional hardware needed

2x 4x12 screws (or longer)

Comment & Rating (9)

@user_1363179018

Print Profile

BBLmattePLA,0.16mm layer, 3 walls, 15% infill

Small nice print. The holder and the hook fits perfekt together

@Ga73eT

Print Profile

BBLmattePLA,0.16mm layer, 3 walls, 15% infill

fit perfectly

@noblepeanut

Print Profile

0.12mm layer, 4 walls, 50% infill

perfect as described

@filip_everberg

Print Profile

BBLmattePLA,0.16mm layer, 3 walls, 15% infill

Bed Adhesion Issue

The designer has replied

@DDAAANNNIEELLL

try to clean your bed. is an easy print and should not get adesion problems as the profile is a standard BambuLab matte PLA profile. did you used an other filament?

(Edited)

@kevin.hoehne

I hate it when people devalue designs because of bed adhesion problems, especially if the model only has a flat bed contact surface. It is not the fault of the model. It is a user only fault. Maintain and calibrate your printer and print bed accordingly, use the right bed sheet and filament combination combination and you will be good to go.

(Edited)