Happy Halloween!

This is a print in place hueforge Halloween card that no one will think of throwing away if they receive it!

Post Processing Instructions:

Once printed, you will need to have a lighter, or a blowtorch to heat up the middle seam (it's the thin one down the middle of the print) to make the card ‘foldable’. Once you've heated it up enough, you will be able to fold it into a card. Do it slowly, and bit by bit so it doensn't accidentally warp other areas of the card.

Options:

I this make I have provided the STLs for both the card as well as JUST the Halloween image, if you're not interested in the card format. Both instructions for the hueforge print are exactly the same.

Print Instructions:

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

Filaments Used:
- PLA Siddament Black Transmission Distance: 0.2
- PLA+ Sunlu Orange Transmission Distance: 5
- PLA META Sunlu White Transmission Distance: 9.6

Swap Instructions:
- Start with White

- At layer #10 (0.52mm) swap to Black
- At layer #28 (1.24mm) swap to Orange
- At layer #39 (1.68mm) swap to White for the rest.