Music DJ - Drink Coaster Set with holder
Copyright Claim
Music DJ - Drink Coaster Set with holder
Boost
3
5
5
This model is created by Make My Sign
Make Your Model
Print Profile(1)
2 Plates - 0.2mm, 2 walls, 15% infill
Designer
5.5 h
2 plates
Boost
3
5
5
0
9
27
Released
Description
Music DJ - Drink Coaster Set with holder
This set includes:
- 4x individual DJ type coasters (90mmx90mmx2.5mm)
- 1x coaster holder (on the second plate in the print profile or find attached as a stl).
Designed to be used with Bambus AMS system using 2 filaments, black and white.
Designer Print Profile:
Please use my print profile. I have set some very specific settings for best possible print. This includes:
- Coasters are facing down, intended to be printed on the Textured plate.
- White has been selected to be the first filament to print, to prevent contamination of the print.
- Thoroughly tested as in my pictures.
- On the second plate you will find a custom designed holder for 4 coasters.
I hope you like it. Thanks for your support. And please check out my other models.
Powered by Make My Sign from MakerWorld (makerworld.com/makerlab/MakeMySign)
Comment & Rating (5)
All
The Coasters came out nice. But there are no Holder, and there is a problem with two of the Coasters, because by two of them the First layer starts with black and the white colour starts in the second Layer, so its a little bit in the air.
The designer has replied
0
Reply
You are right, the second plate i uploaded has disappeared. not sure if Bambu did that? I’ll upload it again in couple of days adter returning from a family holiday. Sorry for your troubles.
0
Reply
Replying to @OzButcher78
Hey, don´t worry. Thanks for your answer and solving!
0
Reply
Print Profile
2 Plates - 0.2mm, 2 walls, 15% infill
0
Reply
Print Profile
2 Plates - 0.2mm, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoDerivatives
© 2024 MakerWorld