Glas Riser with LED etc..
Remixed by
Copyright Claim
Glas Riser with LED etc..
Remixed by
Boost
27
76
18
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.9 h
4 plates
Boost
27
76
18
0
170
213
Released
Description
- Break-out cable entry at the front and back
- 12mm LED are possible
- the LEDs can be attached with cable ties (holes in the model)
- a lip in front of the LEDs so that you are not blinded
- connection of the individual parts using a connector in the shape of a bone. This makes it easier to adjust the fit of the parts later
Comment & Rating (18)
All
Hi,
I havent printed you design yet, because I am puzzled by the vertical pillars that are attached to the front lip. What are those for? Is that just a support?
Greets,
Hauser
The designer has replied
0
Reply
hi,
einfach mit meinem Profil drucken und mit dem Support entfernen. ohne diese Stützen funktioniert der Support nicht so richtig
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Do you have the link of the led strip from Amazon? Thank you
The designer has replied
0
Reply
not Amazon but AliExpress
https://a.aliexpress.com/_EGhIwtR
0
Reply
Replying to @duck.knapp
THANKS
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfetto
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
PLA should work fine
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld