Yennefer of Vengerberg - from the Netflix Witcher Season 3

Note: The roll of Fuschia colour that I have prints purple when it's a thin layer over black, hence why the print looks purple. If you have an actual purple filament, it will be safer.

The included stl file is for a 97x97mm print, however I printed it at 200mm x 200 mm. You can adjust this in your slicer but BE CAREFUL to NOT have 'Uniform Scale' ticked otherwise it will also scale your z height and you don't want that!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Siddament Black Transmission Distance: 0.2
• PLA+ Sunlu Fuschia Transmission Distance: 6.8
• PLA Sunlu Beige Transmission Distance: 8.2
• PLA Sunlu Lilac Transmission Distance: 6.6
• PLA Sunlu Beige Transmission Distance: 8.2

Swap Instructions:

• Start with Black
• At layer #16 (1.36mm) swap to Fuschia
• At layer #20 (1.68mm) swap to Beige
• At layer #28 (2.32mm) swap to Lilac
• At layer #29 (2.4mm) swap to Beige for the rest.

Your filament settings and mine may differ in TD, so best to adjust yours according to your known TD filaments.

Category: Other