Count Dooku's Lightsaber Remixed by jarvizar

Remixed by

jarvizar

Props & Cosplays>Other Props & Cosplays

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.15mm layer, 3 walls, 15% infill

Designer

8.2 h

4 plates

4.8(13)

Boost

134

164

245

Released

Description

3D Model of Count Dooku's Lightsaber Hilt!

Originally created by CaseStudyno8

https://www.thingiverse.com/thing:1571057

I spaced out the pieces onto separate plates by color and tweaked the original model(s) for easier use with Bambu printers.

Personally I used PLA basic filament for the black and red pieces, and PLA silk for the silver and gold pieces.

Supports are recommended for the outer grip and possibly curved emitter, but not strictly required. Some parts will fit together with friction but most will need a bit of super glue to permanently stick.

Collection of other lightsaber hilts: https://makerworld.com/en/u/1935755220/collections/41572

Comment & Rating (14)

@neil.holmes

Print Profile

0.15mm layer, 3 walls, 15% infill

probably one of my fav prints so far and so well guided and set up by the creator

(Edited)

@kanesoldman

Boosted

Print Profile

0.15mm layer, 3 walls, 15% infill

Super print. I used tree supports from the bed for the tall parts of plate 1 (first time using) and it worked great and was a good exercise in how that process works. I used some alternate colours as I didn't have red or gold and will either paint it likely reprint and swap out the parts later.

@CalvinSmithDev

Print Profile

0.15mm layer, 3 walls, 15% infill

Great model, awesome profile. Really good print!

@mjharrop

Print Profile

0.15mm layer, 3 walls, 15% infill

great design, but the designer provided profile could use some added supports. it printed successfully but their were some significant defects in a few bridging areas. on the silver parts.

(Edited)