Remix of a model by wotfan, who does all kinds of cool stuff, check them out.

The original model of this is meant to be a fairly thin, flat refrigerator magnet. I've remixed this to be much chunkier with more of a 3D feel.

For the remix, the original has been resized to 200%. The main body is basically 3 layers of the original model stacked on top of each other. The top layer has the yellow part removed, the middle layer is colored with only yellow and black, and the bottom layer is colored all black. The result is more like a small plaque, with the red and black lettering raised above the yellow background.

There are two plates, one has just the logo itself, and the other has cutouts in the back for 8x2mm magnets, which can be purchased on Amazon and elsewhere.

Note that because of the way this was pieced together with layers from copies of the original, there is a lot of embedded structure created internally that you can see when it's printing. I tried merging the objects in Bambu Studio, but it started doing weird things. Other than slowing down the print just a bit, the internal objects don't really do anything, and in the end everything prints just fine.