Meta Quest 3 controllers and goggles wall hanger stand
Copyright Claim
Meta Quest 3 controllers and goggles wall hanger stand
Boost
24
53
14
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
2.3 h
1 plate
0.2mm layer, 4 walls, 15% infill, STANDARD supports
Designer
3 h
1 plate
0.2mm layer, 4 walls, 15% infill, PETG support for better removal (AMS NEEDED)
Designer
2.9 h
1 plate
Boost
24
53
14
1
175
142
Released
Description
This is my Meta Quest 3 hanger.
It have very good fit for goggles and controllers, because their 3D models were used for this project.
I recommend to use 3 screws to place it on place (wall) - no glue needed.
###################
Update 19.01.2024
Project is still alive.
Just today I added new version of controllers holders - now you can also place there controllers with aliexpress straps (check out photos)
For people who use silicone covers - I prepared ring holders. It also should be good for you. Better than old ones, as previous version was intended for “naked” controllers, without any covers.
Comment & Rating (14)
All
Thank you, perfect! :)
1
Reply
Boosted
great design
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
works perfect and printed well with a .6 nozzle in just 2 hours!
1
Reply
What is the total height for this when the quest is on it?
The designer has replied
0
Reply
About 45cm
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill, STANDARD supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld