In order to keep the sink simple, I designed this storage box for sponges and vegetable cloths There are enough ventilation holes above and below to help the sponge dry and drain to avoid humidity. The front lid is designed as flowers and cherry icons to enhance breathability and beauty You can freely choose whether to install the flower or cherry blossom pattern panel

The initial version design is attached to tiles or sinks with suction cups Considering that some homes may not have suitable surfaces for suction cups (if there is a suction cup, it may be different) So I switched to the common double -sided adhesive in the home (I use 2mm foam double -sided tape)

I use a white PLA for printing. There is no problem in using it. You can try to change the cherry blossom panel to pink Change the flower panel to yellow or other colors you like

note:

1. If the storage box is attached above the tile above the sink, it is recommended to squeeze out the excess water from the sponge before putting it in to prevent too much water and speed up drying
2. If the storage box is attached in the sink, you can place the sponge directly in it. It is recommended to use waterproof double -sided tape
3. Be sure to clean the surface with alcohol and press firmly to ensure the best adhesion

The printing settings are A1 mini preset printing, 200mm/s, 15% infill, and 3 layers of the wall The total time of printing is 2 hours and 51 minutes Please modify it according to your printer type and preference

This is my creation and I uploaded it. If you have any suggestions, you can tell me, thank you