AMS Tall Feeder Button
Copyright Claim
AMS Tall Feeder Button
Boost
31
63
14
Print Profile(1)
0.16mm layer, 5 walls, 25% infill
Designer
1 h
1 plate
Boost
31
63
14
0
105
71
Released
Description
AMS Tall feeder button
Key features:
- snaps on existing button and doesn't move at all,
- taller body for easy access when AMS lid Riser is installed,
- high angled tip for easier push of the knob and easier insertion of filament
Comment & Rating (14)
All
Really wanted to love these but you can't get them on without lifting the AMS guts upward to give more clearance. And then once I did that, it still didn't fit proper, cracked before I could get it on? Idk maybe OP can chime in on this. Not impressed.
(Edited)
1
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
edit….. well they were the greatest ever until I went to close the lid. They don’t work when trying to close it. see last photo.
The best I’ve tried out of three different types. the fit is super tight and locks great into place. start from the front and while holding the AMS push it back as if your feeding filament. they’ll snap down into place.
(Edited)
0
Reply
安装后无法盖上盖子
1
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
printed ok.
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
print profile was good but unfortunately I could not get them on my AMS at all
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
top
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
these are the shiznit.
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
The designer has replied
1
Reply
Thank you for 5 stars.
0
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
1
Reply
Print Profile
0.16mm layer, 5 walls, 25% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld