Print Profile(2)
0.12mm layer, 3 walls, 15% infill
Designer
4 h
1 plate
0.12mm layer, 2 walls, 15% infill
Designer
3.9 h
1 plate
Boost
25
34
3
0
26
12
Released
Description
A skeleton phone stand, easy to print BUT make sure the first layer speed on the skeletons is max 30m/s.
Otherwise they might fail.
Be sure to glue or weld the skeletons to the coffin so its stable.
You don't have to glue the pegs to the skeleton.
Be sure to upload ur makes!
I love seeing my models printed!
Comment & Rating (3)
All
Print Profile
0.12mm layer, 3 walls, 15% infill
overall the print came out good. The support where the phone rest was a little difficult to remove. this will definitely work. I would personally reduce the design by about 8-10%
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
it printed out fine, some of the pieces that go with this model didn't "fit" properly. it works.
1
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld